Model No:- mLabs-SK8000
Chair Unit Specifications:-
Width :- 450 mm to 500 mm
Length (minimum) :- 1830 mm( 6 feet)
Dental Chair Features & Sub Systems :-
Air Rotor terminals
The Dental Chair shall have minimum two high Speed Air Rotor terminals with water control on coupling with at least one fiber optic terminal. Should have one Air motor terminal with speed control preferably fibre optic, with speed range of 300 – 40000 RPM in standard mode with cutting power in the range between 50 – 70 watt. Should be provided with the Brushless.
Ultrasonic Scaler
one unit of in-built Piezon LED Ultrasonic Scaler (frequency 28-36 KHz) with 4 scaler tips and one set of perio-curette tips. Hand pieces to be supplied with Dental Chair unit
“Hand pieces (all European CE/ US FAD Certified Genuine instruments): Fibre Optic Air Rotor(scratch resistant, Titanium Body) – 1 No., Fibre Optic Micro-motor straight (scratch resistant, Titanium Body) – 1 No., Fibre Optic Miniature Air Motor hand piece – 1 No.”
Dental Camera System
Hi resolution LED Dental Camera system with digital signal processor along with ≥ 15” LCD Monitor mounted on the Dental chair.
Air Compressor
Dental Chair shall be supplied with suitable oil free, noise free Air Compressor, with capacity to run up to three dental chair units simultaneously.
Certifications
Electrical safety conforms standards for electrical safetyIEC60601-1(OREQUIVALENT international/ national standard) General requirement for Electrical safety of Medical Equipment (proof to be produced by Seller on Buyer’s demand)
Turnkey Work & Accessories
Scope of Installation
Installation of dental chair & development of operator’s work area [12 feet x 12 feet area per dental chair unit] as per scope defined at tnc
Warranty & CMC
Warranty (Option of comprehensive warranty is available through bidding only, which if opted will supersede normal warranty in the catalogue) – 5
Whether Seller agrees to enter in to Comprehensive Maintenance Contract (CMC) with the Buyer at the expiry of warranty period as per mutually agreed rate between buyer and Seller? – Yes
If Servo Voltage Stabliser of appropriate ratings meeting ISS specifications (input: 160-260 volt) and output 220- 240 V , 50 Hz offered to be supplied with offered Dental Chair unit – Yes
Chair Unit Specifications :-
Chair Unit Specifications
Should enable the operator to be in close proximity of the patient to provide optimum vision of the operating field and safe control of all component devices.
Ergonomics
The chair should be designed to provide good ergonomics for both operator and assistant. Chair should have adjustable ergonomic headrest.
Power drive for Chair movements
Dental Chair shall be fully motorized, pneumatically / electrically driven, which gives smooth movement and non-jerky start and stop.
Power Input
220 – 240 V AC, 50 Hz
Power Supply
Should have integrated power supply for fiber optic handpieces, piezo electric motor etc
